ESR meter built in seconds
On Tue, 25 Jan 2011 12:29:44 +1100, Phil Allison wrote:
"Jeffrey Angus"
William Sommer******
Set the audio gen to about 100kHz and connect the output across the
electro under test -- then connect the scope probes directly to the
same cap (not the generator). You should see a small voltage at
100kHz on the scope.
If one takes that literally, the scope probes /will/ be connected
directly
to the generator.
Did you leave something out?
Nope, it IS connected directly to the generator. And the capacitor
across both.
** Connection of the scope direct to the electro cap is important.
Otherwise, the inductive reactance of the cable from the generator ( at
100kHz ) to the cap becomes included in the scope display of ESR - and
is often more than the ESR of a good cap.
..... Phil
So the cap goes before the scope leads?
--
Live Fast, Die Young and Leave a Pretty Corpse
|