Bob La Londe wrote:

"Michael A. Terrell" wrote in message
m...

They will be used to mill some plastic right now. I bought a new 5"
Drill Press Milling Vise recently, and will have to do the work on my
drill press, since the two mills I usually have access to are both over
scheduled right now.

Would you mind telling us how that works out? I have always struggled with
plastics.


Sure. I have to cut some clean holes in some plastic external hard
drive cases. The OEM molded a pair of holes over one set of latches,
but not the other. I also have to make a pair of tools to depress all
four latches at the same time. They will be pairs of 1/8" drill rod
with either wood or aluminum handles. I'll try to get some photos of
each step. I still have two new cases to practice on before opening the
ones with drives.


The reason for this job is they are usable for both USB or Ethernet
interfaces. The ethernet interface doesn't show up as an IP address, so
they are invisible on your network. I use them to store driver software
and utility programs for repairing computers. Also, you can use a set
of three as a small RAID system.


--
You can't fix stupid. You can't even put a band-aid on it, because it's
Teflon coated.