On Mon, 20 Dec 2010 20:02:26 -0600, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:

Ignoramus30024 fired this volley in
m:

Then you would be right at home with EMC2!

If one of the vendors sells a kit version with EMC2, I'd be happier than
a pig in slop.

I'm NOT terribly happy with some of the inherent quirks in the BOSS9
control. I have an engraving project I've been fiddling with in the odd
half-hour of spare time for over two months. It just "e-stops" for no
visible reason; every time, at the same line of code. Nothing out of
range, no axis limits exceeded, nothing except in the FIST log a cryptic
"motion command that took too long..." (or some-sort; I don't have the
message handy now) and part of the message cuts off at the edge of the
field. But I cannot find anything it exceeds.

It's in a G03 block, and I run G3s and G2s all the time for cornering
blocks. I'll figure it out, and it'll probably be something like
(haven't explored this) the center of the arc being outside the "frame"
of the work area... It is prepping a very gentle curve when it fails.

LLoyd

One assumes you have tried other code totally different from that
particular line?

Gunner

Top 10 Democrat Party Slogans

10. Bitterly clinging to aborton and taxes
9. We didnt destroy your freedoms, you can
visit them at the Smithstonian
8. If you want us to listen to your opinion, move to Europ
7. Someday none of this will be yours
6. We can't tax terrorism, so who cares?
5. Please don't vote us out!! None of us can hold a real job!
4. Why the Founding Fathers limited Government:
Racism!
3. Reducing America's carbon footprint, one job at a time.
2. America: We just cant wait to see how it ends!!
1. Making everything in this country free, except you.