The mill has a sump, where coolant is supposed to be, and where the
tramp way oil also collects. I always wanted to install a skimmer to
remove the oil, and finally got around to doing it after a discussion
on emc-users.

This is a belt type skimmer. It is similar to McMaster item 2165T11.

While the skimmer works, it could not pick the oil since the oil was
not fresh and the oil film would not move towards the skimmer. So, I
fired up the coolant pump, which seems to be doing a fine job at
breaking the surface tension and getting the oil to the skimmer.

After about 4 hours, most iol was removed, but I will run it overnight
to really clean up and start with clean, fresh sump. With new tramp
oil, if I run the pump often, the oil film will be drawn to the belt
without having to run the coolant pump.

I also have McMaster item 2144T51 (disk type oil skimmer) for sale,
price $70. It is called "Abanaki Mighty Disk Oil Skimmer".

i