Karl Townsend wrote:

Existing ATC has WAY more I/O than that. About 18 outs and 24 - 30
ins. I could reduce ins considerably with two encoders. But, that's
next year's problem.

Good grief, are you sure? Looking at it I can't see where they could be
using that many I/Os.

I've only spent a few minutes with the ins going to the ATC. Just
enough to know there's no need to wire now. But I did count 30 and
have to leave that much room on the input panel for later. The outs
are connected and the solenoids all click, Here's a note listing:

relay green tape power panel - coolant
110- SOL 3R Key lock (Right)
110- SOL 7 Shift H
110- SOL 8 Shift L
110- SOL 11R Drum Revolution CW(Right)
110 SOL 12R Drum Revolution CCW (Right)
110 SOL 13R Drum Revolution Rapid (Right)
110 SOL 14R Drum Pin Out (Right)
110 SOL 9 Oil Mist
110 SOL 10 4 axis clamp
110 SOL 1R Arm Forward (Right)
110 SOL 2R Arm Down (Right)
110 SOL 4R Arm Swing (Right)
110 SOL 5R Unclamp (R )
Keylock (L) SOL 3 (L) 110
Drum Revolution CW ( L) SOL 11L 110
Drum Revolution CCW ( L) SOL 12L 110
Drum Revolution Rapid (L) SOL 13L 110*
Arm Forward (L) SOL 1L 110
Arm Down (L Sol 2L 110
Arm Swing (L) Sol 4L 110
Unclamp (L) SOL 5L 110
hydraulic pump
Spindle Brake 110 volt Or Z axis clamp


Look to the bottom of the IO panel. Its the Opto with all 24 red wires
connected. I'm OUT OF OUTPUTS! The 72 inputs look to all be spoken
for also.

I'm working on a trick to get 16 more outs from the two galil boards
at the very bottom of the IO panel. Don Foreman did the design work on
my last CNC mill when I ran short on that one. Generation 2 will be a
slight improvement. Right now, I'm only a couple short that I know of
- oil cooler and air blast, but there will be more.

Karl


You could use a couple of the outputs and run them through a binary to
decimal converter. Two outputs would change to four outputs, four
outputs would control sixteen outputs.

John