Pete wanted to see my machine. I made NO ATTEMPT to clean up. Lots a
wires hanging around. You can see I'm not done yet.
Problem of the moment is not being able to turn the Z axis ball screw.
I started work on the Z while waiting for some stupid little pins from
Mouser. Otherwise, X and Y servos are ready for testing. I normally
finish one step before starting the next.
The two panel pics is where I've been living lately. Still a lot of
connections to complete. I have the control running and I check out as
I go. Perhaps a more experience refitter would wire the whole damn
thing then check out.
Lots of pics have the camera turned, they are sideways in the dropbox.
http://www.metalworking.com/dropbox/..._left_high.JPG
http://www.metalworking.com/dropbox/...high_front.JPG
http://www.metalworking.com/dropbox/...a_io_panel.JPG
http://www.metalworking.com/dropbox/...left_front.JPG
http://www.metalworking.com/dropbox/..._left_side.JPG
http://www.metalworking.com/dropbox/...ower_panel.JPG
http://www.metalworking.com/dropbox/...right_side.JPG
http://www.metalworking.com/dropbox/...ol_changer.JPG
http://www.metalworking.com/dropbox/...a_side_low.JPG
http://www.metalworking.com/dropbox/...ra_spindle.JPG
http://www.metalworking.com/dropbox/...lief_valve.JPG
http://www.metalworking.com/dropbox/...s_coupling.JPG
http://www.metalworking.com/dropbox/...axis_servo.JPG
Karl