....
I have a Bridgeport with an Anilam Crusader II control. I replaced the
servo motor drives with new AMC drives. They are set up pretty much like
your mill IIRC. The servos have tachometer feedback going to the drives and
the control sends +/- 10V to the drives for velocity command. The DRO
scales feed back the actual position of the table, not the position of the
motor. I have used my with the Crusader II control and that works fine for
most purposes, I do hope to do an EMC2 upgrade in the future though.

Roger, are those scales quadrature? If so you could just hook'em up to
EMC.

Karl