"sam" wrote in message
...
In article , anneb3
@mindspring.com says...

No but I just bought a used set like sold by Garrett Wade- a 3 piece
set.
Have not actualy cut any threads, but looked at it today. Don't know if
the
wooden box has shrunk with age- but I have to cut my dowel a little
smaller
than 1/2 inch to feed it into the screw box. Will do some experiments
and
see just what will fit.

I have some mesquite that should make nice threads and nuts.

I have been reading on the Net about using mineral oil as a lubricant,
Will
see what happens
Anne
"sam" wrote in message
...
Has anyone had any luck making their own screw box?

Thanks,

s


I saw where I can buy a tap and box for 30 dollars (plus
shipping). That's probably the route I will go.

Thanks,

s

I used to make 1&1/8" glue blocks for the lathe using a regular tap. No
problems at all. All you need is the tap and the appropriate size drill.