Does your drill resist being grabed and led into the hole?

Does it resist the pull of the tooling when the tooling starts to act like a
screw instead of a drill? Yes. Quite well actually. It also resists the
surge that happens at break through so as to minimize the burr as much as
possible.

Does it resist finding the center of an existing hole? I don't think this is
what you meant to ask, but hey... One never knows! This is essentially the
same question as "will it hold center when drilling on the curved surface of
a round tube?" To some degree, but that's what drill bushings are for in
high volume job applications.

Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com
Production Tapping: http://Production-Tapping-Equipment.com/
Flagship Site: http://www.Drill-N-Tap.com
VIDEOS: http://www.youtube.com/user/AutoDrill
TWITTER: http://twitter.com/AutoDrill
FACEBOOK: http://tinyurl.com/AutoDrill-Facebook

V8013-R