On 2010-09-02, Ignoramus28169 wrote:
On 2010-09-02, Bob La Londe wrote:
[ ... ]
Are you using a peck drill g-code or your own routine to simulate a peck
drill cycle?
It should retract at max speed, which makes a difference.
Yes, I used peck drilling cycle and it did retract at max speed (it is
actually fun to watch). It also plunged back down at max speed also.
It *should* do that -- and switch to normal feed speed about
0.020" clear of the last cut bottom or so.
Enjoy,
DoN.
--
Remove oil spill source from e-mail
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---