Deep drilling aluminum
Bob La Londe wrote:
"Ignoramus4117" wrote in message
...
I was making something on the CNC mill last night. It is a little
block that I would clamp to the quill of the mill, so that I would
attach the Loc-Line coolant line to the quill. That way the coolant
would follow the cutting tool as the quill is raised or lowered.
Anyway, as part of that, I had to drill a deep hole (comparatively). I
used a peck drilling cycle and it worked, but took way too long, with
withdrawal of the tool and lowering it down, etc.
So I wanted to double check what is the recommended procedure for deep
drilling aluminum.
My feeling is that at the given RPM of 2400, I should have used a much
more aggressive feed rate than I used.
I
I have stuck and snapped a couple drill bits peck drilling aluminum with
what I thought was very conservative feed and step depths.
Too conservative can cause problems as well with not evacuating chips
fast enough and resulting binding.
|