Meat Plow wrote in message
news
On Wed, 11 Aug 2010 08:22:10 +0100, N_Cook wrote:

Two of these known to the owner of this one have shown the same
symptoms, but never connected together in any way. The other one
apparently corrected by a factory reset (coincidence?) At switch on the
display continuously scrolls as though one of the up or down bank select
pedals
is active, ie looks like the action of someone continuously turning the
rotary encoder switch.
Have taken apart but not reassembled yet , unenclosed . Only 0.2mm
differentiating first touch to click over of the very basic click
switches under all the
foot pedals. The "wah-wah" switch is different action. Is it a stock
fault
of deflecting steelwork/pivot wear/bending pcb/expanding soft inserts?
causing engagement of these switches, then just washer packings to
correct
for a short time until the problem re-emerges) or something more
electronic/software or internal rotary encoder problem

I never had any problems with my GT6. Used it to gig with from 06 to 08.



--
Live Fast, Die Young and Leave a Pretty Corpse


I asked, at receipt, whether this one had been connected to a pc and it had
not. I've just asked whether it had been connected to a sequencer and so
maybe the other one had as well, transferring corrupted code. This 6B same
as the e-service 6 pdf as far as display is concerned , buffers between uC
and display seem to be operating correctly but still scrolling with the
switch and rotary board disconnected. No obvious ESR problems, little much
else to do, check a few V if 6 and 6B agree there.