On 8/7/10 9:19 PM, Kevin wrote:
You really found that 1/2" flexed too much? How wide is your throat - or
how long? I can't imagine a throat that is so big that 1/2" would flex....
but I'be been wrong before... once...

I think it's about 15". Probably about a foot span from the support
ledges. Doesn't take much to flex 1/2" MDF over that and as far as
I'm concerned when it comes to the TS that insert ought not to budge
if I put any reasonable force on it, because when the sh*t hits the
fan why throw one more variable into the equation?

I didn't notice the flex until using my tenoning jig that rides the
fence. I don't bother clamping the stock in place as it takes too
much time when you have a lot of parts to cut, so you have to put some
significant force to keep it from riding up during the cut. But I
wasn't getting consistent cutting depths and that's when I tested out
pushing down on the insert and could see the sucker flex. If all I
ever did was cut sheet goods I'd never notice and it wouldn't be an
issue.


-Kevin

Your problem lies in your technique. If you are too lazy to clamp or
hold the stock securely to your jig, that's where the danger is. If you're
pushing the stock down to the table hard enough to bend 1/2 mdf over a
12" span, that is poor and dangerous technique.


--

-MIKE-

"Playing is not something I do at night, it's my function in life"
--Elvin Jones (1927-2004)
--
http://mikedrums.com

---remove "DOT" ^^^^ to reply