On 2010-08-04, Gunner Asch wrote:
On Tue, 03 Aug 2010 15:35:15 -0500, Ignoramus30076
wrote:

in the second I
have to add an enclosure for the converter and a plug/receptacle to
the rotary table. This is so, because I may need to unplug the rotary
table and remove it from the mill from time to time.


#1 consideration.. the converter can go inside the old control cabinet.

#2 consideration...never never never put a plug/connector at the rotary
table. Run good quality shielded cable in a length long enough to plug
into the control cabinet on the side or bottom away from the machining
area and all chips and splash.

Yes, I am convinced.

i