Thread
:
Can't do this on a 4x6
View Single Post
#
7
Posted to rec.crafts.metalworking
Steve Walker
external usenet poster
Posts: 58
Can't do this on a 4x6
Ned Simmons wrote:
A 31" long 45 degree beveled cut thru 2" A36 plate. The alternative
was to mill off about 15 pounds of material. Gotta love the cable feed
on that 1945 DoAll. The last pic shows the completed part with an
Ampco metal wear edge welded into a pocket. The 45 on the bronze was
also sawed after welding. The part goes on a hot rolling mill.
http://www.suscom-maine.net/~nsimmons/news/Knife00.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife01.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife02.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife03.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife04.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife05.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife06.JPG
http://www.suscom-maine.net/~nsimmons/news/Knife08.JPG
Very awesome!!
Why is the floor so clean?? G
--
Steve Walker
(remove wallet to reply)
Reply With Quote
Steve Walker
View Public Profile
Find all posts by Steve Walker