In article ,
Ignoramus31310 wrote:
On 2010-07-03, Karl Townsend wrote:
"Ignoramus31310" wrote in message
...
I need to crimp a lot of Molex open barrel terminals for those servo
power supplies. I was kind of shocked to find a tool from Molex for
$269. But then I found item HWS16166 from
http://www.phoenixent.com/
It does a great job.
i
I've got one that's like a pair of pliers. I've been disapointed. Most
crimps are great, then I get one where the wire slides back out of the
crimp
after a while. I started pulling on the just crimped connecter to test them
and it mostly solved the issue.
I will use 20 gauge only for all control connections inside the
cabinet. It seems to work well on 20ga. I also tried it with 24 ga and
it seemed good also.
I always pull on every crimp I make.
Most of the trouble is with 22 guage and smaller. Have you tried this tool
with this fine a wire and checked if they will pull out?
It seems OK, but I will definitely check every crimp.
One uses different terminals and crimp dies for the various wire sizes.
The non-ratcheting pliers type crimpers are almost useless.
Joe Gwinn