View Single Post
  #8   Report Post  
Posted to rec.woodworking
Lee Michaels Lee Michaels is offline
external usenet poster
 
Posts: 1,619
Default 220VAC vs. 240VAC Saw Motor S.O.T.


"Gordon Shumway" wrote

I'll do my best to simplify the answer.

I think its time for me to explain about 240 current and why it is so
different from 120 volt service. First of all, it's twice as big.
Secondly, it'll shock you more. Outside of that, 240 is really two
120 volt lines coming to your house from different parts of the globe.
The up and down 120 comes from the northern hemisphere, and the down
and up version comes from below the equator.

Without trying to get technical, it all boils down to the direction
water flows when it goes down the drain. In the top of the earth, it
goes clockwise, while on the bottom of the earth it goes counter
clockwise. Since most electricity is made from hydro dams, the
clockwise flow gives you an up and down sine wave, while the
counterclockwise version gives you a down and up sine wave. Between
the two, you have 240 volts, while either individual side only gives
you 120 volts.

This is particularly important to know when buying power tools --
which side of the globe did they come from? If you get an Australian
saw, for instance, it will turn backwards if connected to a US
generated 120 volt source. Sure, you can buy backwards blades for it,
but that is an unnecessary burden. Other appliances, like toasters
cannot be converted from Australian electricity to American
electricity. I knew one person who bought an Australian toaster by
mistake and it froze the slices of bread she put in it.

If you wire your shop with 240 and accidentally get two US-generated
120 volt lines run in by accident, you can get 240 by using a trick I
learned from an old electrician. Just put each source into its own
fuse box and then turn one of the boxes upside down. That'll invert
one of the two up and down sine waves to down and up, giving you 240.
DO NOT just turn the box sideways, since that'll give you 165 volts
and you'll be limited to just using Canadian tools with it.


Many years ago, I went to electronics school. The guys there would have
howled at this bit of lunacy.

I am trying figure out if you are really funny or just totally disturbed.
Did you write this or get it from someplace?