On Fri, 25 Jun 2010 10:44:27 -0400, BillMe wrote:

I need to cut an acme thread in a steel block. Roughly 5/8" X 6. I
forget what I measured! Is that done with a tap or a boring bar?
Friends have not heard of an acme tap. Thought someone might know.

Thanks,

Bill A


I may have one of that size. Ill check in the morning

Gunner

One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch