"JW" wrote in message
...

Nice price. I'm working on a 1KW HP 6032A power supply (with outputs
unloaded in this case, so I don't need *too* much current capability) and
need to connect my scope to the hot side of a switching transformer -
specifically the source and drains on the output FETs.

Service manual: (3MB)
http://www.home.agilent.com/agilent/...=-35687.384731
Page 113 shows the schematic of the FET board.

With an isolation transformer, I *think* I would connect the scopes GND
lead the source of Q1 and probe the it's gate to check the it, then move
the scopes GND lead to Q3's drain lead to check it's gate drive.

Given that, would that Ebay transformer be the right choice, and do I need
to isolate (disconnect) the ground on the 6032A power supply under repair?

Thanks.

This is a "bad idea". Better to use a differential input and two probes. Do
you have a two channel scope with invert on channel 2?

Tom