On 2010-06-11, Wes wrote:
Ignoramus28478 wrote:

Brian, thanks for the warning. I already hooked it up to the
converter, so if there was any damage, it may have already occurred. I
think that I was lucky and voltage from lines L1-L2 was applied to the
transformer and such.

i

Okay, I think you got it. Two phases are attached to the generated leg. You do not want
the control power transformer on those. Stick to the line connected leg.

Exactly. I traced some wires last night, it does look like the servo
stuff is using lines L1-L2 and L3 goes to the spindle motor only.

In my 3 phase wiring, I made really sure that L1-L2 are where they
belong.

i