"Ron A" wrote in message
nk.net...
A few questions regarding miter gauges for my Table Saw.
Incra has a V27 that is reasonably priced miter gauge for about $60 but it
only stops every 5 degrees and at 22.5. It is sufficient,
=====================
I own a 2000.... and if you do a search of my posts you will see I have
repeately stated that it was a waste of my money...
Dead on accurate but a royal pain to use..
Besides 90 and 45 degree cuts and an ocassional 22 1/2 I really do not need
all that many settings... So I went about making sleds for 90 and 45 degree
and use them
100% of the time... The 2000 gathers dust in my shop !

Bob Griffiths