"Upscale" wrote in message
...

I've just been looking at the Kreg Deck jig being advertised on Lee
Valley's website.
http://www.leevalley.com/en/wood/pag...28&cat=51&ap=1

I was wondering about fastening deck boards as demonstrated by this
jig. For those of you experienced with building decks, would the
screws need to be inserted on both sides of a deck board, (assuming
there's just enough room for screws to be inserted on a 45 degree
angle both edges) or just on one edge? And if it is just one edge for
fastening down a deck board, wouldn't there be a tendency for the
opposite unfastened edge to rise or perhaps cup over time?

Thanks


Take a lookat this: http://www.youtube.com/watch?v=iTBG29lzKys
Not a very practical device, IMO.