Slitting on a mill
"Gerry" wrote in message
...
On Jun 1, 8:06 pm, "Buerste" wrote:
"Gerry" wrote in message
...
I need to slit a piece of mild steel 0.500" thick and 0.875 deep to a
0.652 hole. This will be a clamp to attach to a motor shaft. Never
used a slitting saw before, therefore I am asking for any advice.
Using a drill/mill with a 3X1/16X1 30 tooth saw. Thanks in advance
I hate slitting saws! Slow feed, robust rigid set-up, flood coolant,
silent
prayers! Can you use a hacksaw or a Sawsall?
I cannot cut straight with either. Hoping to get a cut better than I
could do with a hacksaw
***********************
Does in need to be straight?
|