Well had the codes scaned for my ABS light always on. I got the
following: C0021, c0022, c0026,c0035, c0037.

He asked me if I had unpluged anythign and I told him I had at the
module under the hood earlier in the week. He did some fidling with
his scanner and said the codes came back again and that the unit
either was bad, or there was a ground problem somewhere.

This is my daily driver but has 315,000 on it so I dont want to put
alot of money in it. I do all of the work on it myself. Thing is, I
think it needs a master cylinder. But, if the ABS cant be cylced to
purge air, how can you do it? Elsewhere in this forum someone
suggested a procedure which I am willing to try, but if I mess up and
get somethign wrong and get air in the system I am not sure what I
will be able to do.

1) Is it possible or even feasible to just , with new plumbing,
bypass the ABS module. (Run lines directly from mast cylinder to
brakes.

2) If this could possible be a ground, where do I look?


I will say maybe once every two months I get in it and the light stays
off untill I get on the highway. My hopes go up thinking it fixed
itself then it always comes back. 90% of th etime the light comes on
as soon as the key is turned over.

I appreciate any help as I am at a loss.