On 2010-05-26, Jim Wilkins wrote:
On May 26, 1:17*am, "DoN. Nichols" wrote:
On 2010-05-26, Bob AZ wrote:
* * * * Not if he needs a 3/4" hole. *If you had said a chassis punch, I
would agree -- but knockout punches make oversized hole to mate with
conduit fittings and such.

This one is stamped "1/2 conduit 7/8 dia".

So -- they've started marking with the actual diameter as well?
Not back when I was buying them new. :-)

So -- what size knockout punch would be needed to make a 3/4"
diameter hole? Something smaller than 1/2" conduit -- and I don't think
that they *make* anything smaller. :-)

Enjoy,
DoN.

--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---