On Sun, 23 May 2010 18:01:01 -0500, Ignoramus32683
wrote:

On 2010-05-23, Don Foreman wrote:
On Sat, 22 May 2010 19:02:17 -0700, Gunner Asch
wrote:

On Thu, 20 May 2010 10:47:16 -0500, Ignoramus15573
wrote:

http://igor.chudov.com/projects/Weld...rame-For-Mill/

A little cold..but not bad.

Gunner

It's 7018, which runs quite fluid so I'd say more than a little cold.
Picky picky, I don't doubt that it'll suffice.

I used about 120 amps. I might have had the arc too short.

Was the photo with the ground clamp the first weld?

It'd take me a few minutes to figure out current and rod speed. It's
been years since I've run 7018. 120 amps sounds like the right
ballpark for 1/8" rod, but truth is in the sound and the puddle.