"N_Cook" wrote in message
...
Arfa Daily wrote in message
...
Hi all

Anyone happen to know the value of the resistor in the CR network
connected
in the synchronous motor feed ? Looks like brown - red - brown so 120
ohms,
but it's well overheated and discoloured, with a nice burn mark right
around
the spiral element, right in the centre. Can't get a reading from either
end
to the burn point. Looks at a guess to be rated about 3 -5 watts. Anybody
think of a reason *not* to use a wirewound rather than the original metal
film type ?

Arfa



Wasn't Rega tonearms only?
What sort of vintage is the deck? Is it definitely for use on 240V mains ?


--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://diverse.4mg.com/index.htm


Well, sort of. I guess that the full deck is probably a Rega Planar 3, but
definitely a Rega-original product. There is a "Grahams HiFi London" tested
sticker on the bottom with a handwritten date of '86 on it. There is a
manufacturer's label on the bottom also saying "rega Made in Britain" and
"Rega Research Ltd"

To the best of my knowledge, it has always been used here in the UK.The
motor is a synchronous type, 4 wire, and marked 110v 50Hz. Two grey wires go
straight to mains neutral. Switched mains live comes back to a small
(original looking) PCB in the motor compartment. It passes through the R in
question to to the motor red wire. There is then a cap, 0.22u 400v
polyester, between the red wire and the blue wire, so I guess that this RC
combination is a phase shift / AC dropper so that the motor is happy at
240v. There is no indication on any of the labels as to the voltage specs,
but the fact that it is a 50Hz synchronous motor single speed deck, and also
that the mains lead is absolutely original and coloured blue and brown,
would suggest that this was built for use in europe on 50Hz mains of at
least 220v ??

Arfa