On 14 May, 12:50, Onetap wrote:
On 14 May, 12:41, Onetap wrote:
On 14 May, 07:45, Cicero wrote:
Any confirmed source of these much appreciated.
http://www.bes.ltd.uk/
Cancal that; I've just noticed they only do 8mm. 8mm and a 8x6mm
reducer seems the only option.
Yup - this is the problem I've had - everything starts at 8mm. And
I've looked all over...
Hammering the end flat & soldering is not an option - there are
cosmetic reasons for this.
Worst comes to worst, I'll knock something up on the lathe, but I'd
like to keep it simple...
Cheers