On Mon, 10 May 2010 13:32:47 -0700 (PDT), saber850
wrote:

PCB Designation Farads (µF) Voltage (V) Temp (C) Length (mm)
Potential Length (mm) Diameter (mm) Lead Spacing (Board) (mm) Mouser
Replacement Mouser Replacement URL

C105 150 450 105 41 45 20 7 661-EKMQ451VN151MP40
http://www.mouser.com/Search/Product...MQ451VN151MP40

You probably do NOT need to replace the big 150uF/450V capacitor. It's
not the high voltage low ripple current capacitors that fail. It's the
low voltage, but high ripple current filter caps that get hot and blow
up.

C107 47 50 105 11 24 5 5 667-ECA-1HHG470
http://www.mouser.com/Search/Product...67-ECA-1HHG470

Tolerable. It's not a low ESR type, but it's low enough to work.

C301 680 25 105 17 22 10 5 667-EEU-FC1E681
http://www.mouser.com/Search/Product...67-EEU-FC1E681
C302 680 25 105 17 22 10 5 667-EEU-FC1E681
http://www.mouser.com/Search/Product...67-EEU-FC1E681

It's low-ESR (although the data sheet doesn't clearly show this) so it
will work.

C110 820 25 105 22 24 10 5 598-361R821M025EG0E
http://www.mouser.com/Search/Product...61R821M025EG0E
C111 820 25 105 22 24 10 5 598-361R821M025EG0E
http://www.mouser.com/Search/Product...61R821M025EG0E

Also low-ESR and good quality cap. No problems.

C112 330 25 105 14 24 10 5 667-EEU-FC1E331
http://www.mouser.com/Search/Product...67-EEU-FC1E331

Looks generally ok.

I'll leave it to you to determine if the case sizes and lead spacing
are the same as the originals. Neither is particularly critical as
there is usually plenty of room. One suggestion is to use the next
higher voltage rating capacitor. The 50v cap will probably remain
50v, but the 25v caps should be replaced with 35v caps. They last
longer, have a lower ESR, and aren't that much larger.

--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558