This repair service has been mentioned often, although I haven't had them do
any work for me.

They will give you a free quote, according to the info on their website.
http://longislandindicator.com/p30.html

If you have a large gage block (or several) that fills the opening of the
jaws, you should be able to determine if the jaws are square, parallel and
flat at various points along the beam.

--
WB
..........


"engineman" wrote in message
...
I have a Mitutoyo digital caliper that I bought in 1995. It has given
me good service all these years but just lately I noticed that it
reads about .002 over. The reading is about the same all the way out
to the end of the jaws so I know it's not caused by the slide being
loose.
I know I can pick up a piece of Chinese junk for 10 or 15 bucks but I
kinda like this tool. Is there any way I can recalibrate it?
Engineman