"Peter" wrote in message
...
On 4/23/2010 10:56 AM, RBM wrote:
wrote in message
...
I've got a "no-name" clamp-on fluorescent lamp that no longer starts
when
the rocker switch is snapped from the off to the on position. The lamp
has a polarized plug with an in-line black "brick" 7 1/2" x 2 1/2" x 1
3/8" that has the code "G0138" stamped above the code "GG10051F" on the
bottom but no other markings. The 2 conductor cord from the brick goes
to
the base of the lamp where the clamp is located. The lamp uses a single
18W 4 pin double tube bulb with code G24q-2.

I'm sure that the bulb is good because I have a second, identical lamp
(that works normally) and when I swap the bulbs, the "good" lamp works
perfectly with the bulb from the lamp that is not working. I also have
a
brand new spare bulb that I've tried in the non-functional fixture and
it
too fails to light in the bad fixture.

The problem started spontaneously with no earlier indication of
problems.
Normally, when the lamp is turned on, there are a few quick white
flashes
in the bulb and the bulb lights and glows steadily. The behavior I
observe is that when I snap the rocker switch to on, the bulb either has
one quick white flash but then I only see the heaters glowing in each of
the two tubes, or there is no white flash at all, and all I see is the
glow of the heater filaments. I've tried plugging the lamp into another
outlet in case the problem was related to grounding (I've read that
these
quick start bulbs need their circuits and fixtures to be grounded to
work
properly) but it did not help. The "brick" has always been entirely
quiet
and never got particularly warm, and that has not changed.

Any suggestions (besides ditching the lamp)?

I think that what you're calling the "lamp", what I would call the
fixture,
has a bad ballast transformer. If it is integral to the fixture, it's
probably not worth trying to replace.


Thanks for the clarification and the feedback. Yes, I was using "lamp"
and "fixture" interchangeably, in distinction from the "bulb". You're
right, "bulb" and "lamp" are closer in meaning; "fixture" is the entire
unit from plug to bulb.

I opened the "brick"(held together by 4 small recessed screws)after
sending my inquiry and it appears to contain only a ballast with 2 wires
at each end (this conforms with the wiring diagram on the ballast label).
The label identifies the ballast as a Fu-chi brand PC-4526P-B 300 mA for
PL-C 18w. Extensive work on Google has failed to yield a useful hit for a
replacement. The closest I saw had 3 output wires and no dimensions were
provided.

That's what happens when Google gets kicked out of China. It may be possible
to get a replacement from the manufacturer of the fixture, but more and
more, I'm finding that approach fruitless as well.