" wrote in
:
Won't fit. *No riser attachment :-(
Uhhh...you aren't standing the things on end, you know *
Surely, your saw is big enough so you can lay a 4x4 rail flat on the
tabl
e
and shove it into the blade at an angle. *You know, taper. *Or use a
hatchet.
The cuts are not made on a flat face. They are made across 2 faces.
And so they don't fit under it since it must ride in on the V part of
the timber. When it is stood on that edge, the height is right at 6"
or more, remember I said they are not perfectly flat square stock. A
hatchet works ok when making one end, but making 2 parallel ends is
more challenging!
Temporarily nail a plank to the bottom to serve as a reference. Then cut
them on a bandsaw with the plank resting flat on the table. It may be
easier to cut both ends fresh using the plan than to try to nail a plank
square with an existing end.
Doug White