Glen wrote:
Here is the answer to my own question. There are four bolts all near
each other at the front of the saw. Two can be reached from
underneath with a socket wrench. The third can be loosed through the
throat plate with the blade removed with a open end wrench. The
fourth can be left tight and used a pivot to allow the saw to be
tapped into alignment with tap on a block of wood through the throat
plate.

There is a very specific way to adjust a contractor saw....and it
requires a lot of screwing around.

Go here for those instructions;

http://support.dewalt.com/cgi-bin/de...PWFsaWdubWVudA!!


I would also do some reading at the TS Aligner site