When is an M45x3 not a 1.75x8 thread?
"Doug Miller" wrote in message
...
In article
, Bob
AZ wrote:
Anyone have a seller of M45x3 nuts so I can check the spindle nose?
There are NO points for Grainger or McMaster.
Louis
The 1.75" X 8 tpi are off too much for M45X3 to be a consideration.
Not that far off: 1.75" = 44.45mm; 8 tpi = 3.175mm.
You probably could get the threads to engage, but the load wouldn't be
distributed among the threads. You'd probably have less than a full thread
in actual contact. That's the real weakness in having "almost" the right
thread.
--
Ed Huntress
|