In message , AlanD
writes
I have a WDG1095 I'm about to scrap if you need the programmer or any other
parts (or the whole machine!) - located in Luton, beds. The programmer is
OK, and may be the same type as yours.

I decided not to repair it as it needs main bearings & seal, belt, dryer
heater and washing themostat (60° cycle OK, 40° not so main heater OK!).
Cost of repair too much to invest into a 10YO machine for my liking.

Alan.



Hi Alan,
sounds good to me, I'll try and find out if the programmers are the
same. I'm only just up the A6 from you at Elstow. My machine is about
the same age as yours but has only had a couple of years use as it is in
an annexe that hasn't been occupied for quite sometime. The fault it
has was found by my mum in law some years ago when she used it so at
least it's not been caused by being in storage.
--
Bill