"Jim Wilkins" wrote in message
...
On Feb 15, 5:28 am, "Royston Vasey" wrote:
I'm trying to seal a printed circuit board into a PVC part I've turned out
on my lathe. The problem I'm having is the that the epoxy goes quite runny
as it goes through its curing process and some of it runs through small
gaps
( 0.5mm) where I'd prefer it didn't.
...
Has anyone played around with this type of problem?
thanks.

I use 5 minute epoxy to sculpt freehand shapes. A small jet of hot air
will make parts of it set up faster.

jsw

I'm off the hardware - I'm going to give some quick set expoxy a go before
looking at more expensive options. Cheers.