On Mon, 15 Feb 2010 18:28:26 +0800, "Royston Vasey" wrote:

I'm trying to seal a printed circuit board into a PVC part I've turned out
on my lathe. The problem I'm having is the that the epoxy goes quite runny
as it goes through its curing process and some of it runs through small gaps
( 0.5mm) where I'd prefer it didn't.


I'm using CW177 resin & HY177 hardener in the 5:1 mix recommended.

The data sheet is he

http://www.meury.com.au/uploads/170666853166.pdf

I tried some rapid set epoxy (~90 seconds) but it turns to crap before I can
get it in where it needs to go.


It's not really practical to use anything else (like RTV, tape, hot glue or
wax etc) to seal the small gaps in the bottom of the assembly.

Has anyone played around with this type of problem?

thanks.


Talcum powder or baby powder to thicken resin if strength isn't an issue, chopped fibers if it is,
all are available at any good boat store such as West Marine.
*****************
Thank You


To reply to this email please remove the AT
after the kgs in the reply to address as shown above.

Never ever under estimate the incompetent.