LDosser wrote:
"J. Clarke" wrote in message
...
Bill wrote:
"LDosser" wrote in message
...
"Bill" wrote in message
...
How well does interior grade plywood hold up in a garage? My
garshop drops to about 30 degrees, but the concrete floor probably
gets cooler. Among other things, I was thinking of putting some
plywood under a drill press. I assume that the interior grade
stuff would probably be fine for jigs and things like that--how
about a router table?

If you cover it with melamine or similar. As is, it has too much
stiction.

So you are saying that it would maintain its structural integrity?

Does it get wet? If not then it will do fine.



Would you use a plywood surface for a router table.

If its covered with melamine or the like. I used MDF on mine--it works
fine.