"Morris Dovey" wrote in message
...
On 2/9/2010 5:52 AM, LDosser wrote:
"Upscale" wrote in message
...
On Tue, 9 Feb 2010 03:30:18 -0800, "LDosser"
wrote:

That's something like it, but the one I saw had a couple wheels for
rolling
the panel to the saw.

Think I remember the cart you're referring to. It was hinged at both
ends at 2' where the middle of a 4x8 sheet of wood would sit in the
cart. One would then swing the 4x8 sheet parallel to the ground and
then slide it onto a flat surface or a table saw for example.

Sounds like.


Someone will post the link to it.

I searched, but didn't find anything close.

I kinda like this one:

http://www.iedu.com/DeSoto/Projects/PanelCart/


That's what I'm talking about!!