On Mon, 8 Feb 2010 21:07:21 +0800, the renowned "Royston Vasey"
wrote:


I'm forming some wire mesh cloth - that part is going ok.

The finished part needs to be compressed to fit into a pvc part - working it
in by hand results in scratching and marking of the pvc. I'm looking for
some ideas on how to compress the mesh part so it slips cleanly into the pvc
part. There's a few pics in the dropbox:

http://www.metalworking.com/dropbox/wire_screen.pdf

Stuff it into a stubby thin-walled open-ended tube (maybe with a ring
or other handle at one end) shove the tube into the PVC and then
withdraw the tube while pushing against the top of the screen so it
stays seated in the PVC.

(Sort of how I imagine how a tampon applicator would work).


Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com