Old 230/440 motor and VFD
On 2010-01-20, Wes wrote:
Ignoramus29895 wrote:
Given your ability to find a deal, is there any reason you can't come up with a rpc? I'm
running mine on a Rotophase my uncle found in a dumpster at a oil location he maintained
portapotties at. A motor, a few caps, you are good go to.
I already have a phase converter, but I was hoping I would not need to
use it for the lathe. I have a pile of variable frequency drives, some
are in a bad cosmetic shape (hard to sell) that are quite usable.
i
I don't know enough about VFD's in your application to help you.
It would seem that a motor that is 230/460 which I belive yours in could handle whatever
extra strain a vfd would put on it.
I don't know but would adding some load side capacitance mellow out how your motor reacts?
I'm hoping our EE's on the list have comments on that one.
I am pretty sure that you cannot put capacitors on the output of a
VFD.
Actually right now, the lathe is on a Phase-A-Matic static phase
converter. The Phase-A-Matic came with the lathe. It runs, but I am
getting only 2 HP out of 3. Maybe I should just leave it as is. I
would not be likely to use all of the HP without coolant.
I want to do the right thing, and it is not immediately obvious what
is the right thing. I know for sure that I do not need to vary input
frequency.
It seems that the phase converter route is nicest to the motor, and
lathe, but is less convenient for me.
i
|