Ignoramus29895 wrote:

On 2010-01-20, Wes wrote:
Ignoramus8727 wrote:

Check the various bearing houses. Thats way too much money.


I have not found anything cheaper.

The belt length and angle is odd. Clausing is the only source I've been able to find.

Supposedly, a belt that could fit, is 2528V370, and the lowest price I
could find online, is $92 plus shipping. It is not a popular size like
those starting with 1922, so it is pricey.

By the way... The old belt that I have, is in a bad shape, with the
outer layer separating from the inner layer. Coincidentally, the VS
drive makes a lot of noise. It sounds like a tractor falling down a
steep embankment. Am I correct thinking that this is caused by this
old belt and would likely be fixed by replacing the belt?

i

The drive is fairly loud even when things are working fine. Are you hearing a repeating
sound, you know, does it have a periodic beat? If the back gear and high range pin are
both engaged at any time, the spindle will lock and the orignal owner may have burned a
few spots in the belt. That wouldn't sound good either.

If you take the v belt off and disconnect the hydralic hose you should be able to spread
the motor sheaves. See if you can rock them relative to each other. Can you see a green
coating on the sheave shaft that goes into the delrin bushing?

You have my email address, can you send a 2MB audio recording of your drive? Heck, post
it on your website.

Thanks for supporting the Michigan economy!

Wes
--
"Additionally as a security officer, I carry a gun to protect
government officials but my life isn't worth protecting at home
in their eyes." Dick Anthony Heller