View Single Post
  #11   Report Post  
Posted to alt.binaries.schematics.electronic
Archimedes' Lever Archimedes' Lever is offline
external usenet poster
 
Posts: 571
Default LED Instrument Panel V2.0

On Sun, 17 Jan 2010 10:23:00 -0800, John Larkin
wrote:

On 17 Jan 2010 16:54:58 GMT, mick wrote:

On Sun, 17 Jan 2010 08:35:12 -0800, John Larkin wrote:

On 17 Jan 2010 16:01:35 GMT, mick wrote:

On Fri, 15 Jan 2010 23:02:08 -0800, John Larkin wrote:

snip

There's a pot on the linear regulator; it's in plain sight. And that's
all this thing needs. The PWM accomplishes nothing.



PWM dimming is more efficient than linear dimming - by a long way. It
all depends on how much heat the OP is willing to let the dimmer
dissipate.

PWM is no more efficient than resistive dimming the way he did it. There
are no inductors in his circuit. All this sort of PWM can do is move the
heat around.



I couldn't see his circuit on my server, but I assumed that he was
varying the mark/space ratio. In that case power dissipation in the
output device is always low, depending on Vsat.


That just moves the heat into the series resistors. Overall efficiency
is always the same for a dissipative (inductor-free) regulator.

With a linear regulator and properly chosen series resistors, you can
balance the regulator heat distribution versus dimming level.
Regulator power dissipation versus output voltage is sort of
parabolic... low at low illumination, low at max illumination, peaking
somewhere between.

It's easier to heatsink a voltage regulator than a lot of small
resistors.

Another advantage of a voltage regulator is that it regulates.

John



You take a few of these and drive four sets of LED pairs per chip.

That's $0.50 per LED for constant current, precise control.

Might as well go all out. Beter than any use specific "LED driver" chip
out there.

http://www.edn.com/article/CA6702709.html

http://a330.g.akamai.net/7/330/2540/...6702709XLG.jpg