wrote in message
news
On Sat, 16 Jan 2010 13:39:41 -0600, "Leon"
wrote:


wrote in message
If you would like I can provide you the actual plans although they do not
show my printing on the jig as the prototype does.

I should be ok without the plans. If I have any difficulty
constructing it, I'll email you.

As I see it, the most important factor to the jig is to have the
vertical and lateral sections fastened together exactly at 90?.

Precicely

The
rest should be simple. The only other decision would be how big a
board width capability it needs. I figure a maximum dado length of 24"
should be sufficient.

I was going to make a shorter one abou the length you have in mind and a
longer one, 48" But later ended up buying a dado set as I seldom just make
a few dados at one time. My jig is great and faster for a few quick and
accurate dados.