On Wed, 13 Jan 2010 00:34:45 -0500, "Bill"
wrote:

TY for pointing that out. Good point. But, isn't that a "shaper" bit in
the 4th and 5th pictures
at the bottom of the page??
http://www.deltaportercable.com/Prod...roductID=15685

It's a sanding drum. And yes, it would experience some lateral
pressure similar to what a shaper bit would experience. However, the
lateral pressure would be much less. One other thing to consider too.
Drill presses operate at much slower RPMs than shapers and routers. I
doubt whether a drill press could spin a shaper bit fast enough to
effectively cut wood.