On 1/10/2010 6:34 PM, RicodJour wrote:
On Jan 10, 7:25 pm, Steve
wrote:
Ok, so I found some time to try to get over the hump with Sketchup, and I
brought up the video that Karl posted a few weeks back:
http://www.finewoodworking.com/item/...demonstrating-...
and tried my best to follow along (with lots of pauses and rewinds along the
way). All was going well until I reached the point where he was creating the
lower shelf support by copying two of the upper rails to a lower position, then
using "push/pull" to change their widths (this is right at 3:20 in the video).
At that point Sketchup refused to perform the push/pull operation (the tool
shows a circle with a slash through it), and in fact I cannot "push/pull" *any*
existing surface in the drawing, apparently something to do with the fact that
everything is a component. I can create a new surface (a rectangle, for
example), then push/pull that into a 3D object, and I can continue to stretch
any of its surfaces up to the point where I make it a component, then it's
no-go. What gives? If I create a completely new drawing, push/pull a
rectangle and make the 3D result a component, I can continue to use push/pull
to stretch or shrink any of its surfaces, but in the fern stand document I
cannot, even after saving it, exiting and re-entering Sketchup, etc. Thoughts?
Double click on the component to edit it. You can nest components
(and groups) so multiple clicking might be required to burrow down to
the level where you can edit something.
R
Got durn it! I spent all that time typing that long problem description, and
that's the solution? "Double-click it"? Well let me tell you one thing... it
works! (Settle down there Steve) :-)
Oh wait, I can think of something else to bitch about. Where the *heck* is
this documented? The "Instructor" gives no clue about this type of selection,
and so far the online help and I aren't getting along very well together.
As you can probably tell, I just LOVE learning new software tools. (Grassa
wappa frap!)
--
"Even if your wife is happy but you're unhappy, you're still happier
than you'd be if you were happy and your wife was unhappy." - Red Green
To reply, eat the taco.
http://www.flickr.com/photos/bbqboyee/