Samuel M. Goldwasser wrote in message
...
This printer has served me well for several years since inheriting it
from a friend. It has always been rather light even on maximum dark
settings but is now getting to the point where I'm thinking of actually
buying (gasp!) a new printer.

The symptoms are that thin lines print very light while large areas
are solid black.

The toner cartridge and been replaced with no change.

It's not used very much, mainly for mailing labels and is clean inside.

It seems to me that there use to be settings for darkness in the LJ5
driver
but since upgrading (!!) to XP, they don't appear anymore. That improved
it a bit, though never as dark as it should be. But might be enough.

Any suggestions appreciated.

Thanks!

--
sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above
is
ignored unless my full name AND either lasers or electronics is included
in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.


Damp paper ?
Try passing some sheets through the system, so heated by fuser roller, and
then passing through again the other way up