20 degrees is about the most or you block off access to the TO3s. Maybe only
tinkering at the heat build up problem. Most air must go through the 25mm or
so wide gap in the ps direction (over the tips of the vanes), rather than
the 2 off 5mm gaps to the duct let alone through all those vanes. I would
have thought there should be some shuttering to block off most of that large
gap along the ps side , to force most air round and through the heatsinks.

They were assembled with enough white goo to keep a goth happy for a week.
So much that she filled the B & E holes so pins pushed through it, not
cleaned off, and some white goo actually under the solder joints (not
actually failures there). Those failed caps 47uF, 63V - in similar HK amp
they were rated 40V 47uF , what is the problem in that area of the circuit?