On 2010-01-05, Karl Townsend wrote:


In any case, this Morse 4.5 (four and a half) taper left me
confused. Is that a standard Morse taper, or what is that exactly?
Could I find a center that would fit this spindle?

Page 909 of machinery handbook lists all the specs. for a Morse 4.5 taper.

Depends on the edition -- my 25th edition puts it on page 910.
What edition were you using?

Email me if you need a print screen of these specs.

Karl




--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---