SCMS max cut?
I've got a question about that. With this flipping technique, how exact is
the entire cut? If you're really careful, can you use this method to make
exact 90° cuts for a 24" span? If you were to use a square on this, would it
show any variations?
Thanks
"JGS" wrote in message
...
Hi Grant,
I cannot say which has the largest but my Makita 1013 will cut about 12"
at
90`. However, I can cut about a 24" piece by plunge cutting the first half
and then flipping the board around and starting the second cut in the kerf
of the first. Cheers, JG
|